Starter Vape Kit spec sheet for resale guide
Starter Vape Kit is a specification decision before it is a price decision. Get the resistance, the capacity and the packaging right and the price conversation becomes short. Get them wrong and no discount will rescue the order.
Published 07 February 2025 · VapeWholesaleHub · Reading time 7 min
How orders move from factory to shelf
If you are comparing three quotes for starter vape kit, compare the paperwork first. Test reports, artwork files, batch coding and the replacement clause tell you more about a supplier than the unit price on page one.
Freight on starter vape kits is driven by volume more than weight. Cartons are designed to hit a clean pallet count, which is why a slightly denser pack can cut your landed cost by more than a discount on the unit price ever would.
We ship from Shenzhen and Guangzhou: air express for samples and part loads, sea freight for volume. Typical production lead time is 12 working days after artwork approval, plus transit. We quote both routes so you can see the trade-off instead of guessing at it.
Sell-through notes for the shop floor
Counter space is finite. Three well-chosen SKUs outsell nine crowded ones, and the empty space signals a curated range rather than a clearance table.
Seasonality in starter vape kits is real but smaller than most buyers assume. The bigger swing comes from restocking discipline, not from calendar events.
What we test before a carton is sealed
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
10 separate checks run before a carton is sealed: electrical, mechanical, leak, finish and packaging. Anything outside tolerance is quarantined the same day and reported to you, rather than shipped with a hope and a discount.
- Consolidated or split shipping, quoted both ways
- Document pack prepared per destination market
- Private label files archived for future rebrands
- Batch codes traceable from carton back to production date
- Artwork proof plus physical dummy for custom packaging
- Specification locked in writing before production starts
How the price is actually built
The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.
Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.
Specification summary
| Battery | 500 mAh |
| Pod capacity | 3.0 ml |
| Coil resistance | 1.0 ohm |
| Included | Device, pod, cable |
| Charging | USB-C 5V/1A |
| Packaging | Blister pack |
| Minimum order | 300 units per SKU, mixed cartons allowed |
| Lead time | 12 working days after artwork approval |
The detail above is what we hold ourselves to on every shipment, including the small ones. It is also the list we will walk through with you before the first order.
Frequently asked
Can you ship to multiple locations?
Yes. Split shipments are quoted separately because consolidation and splitting price differently. Tell us the destination list at quotation stage and we will show both options.
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
How long does production take?
Around 12 working days after artwork approval for stock configurations, plus transit. Custom runs add roughly a week for tooling and a physical dummy. We confirm the date in writing on the order acknowledgement.
Related reading
Need a quotation on starter vape kits?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz